5 Common Problems When Making French Macarons (2024)

  • September 13th, 2019

  • Browse French Recipes

5 Common Problems When Making French Macarons (1)

Share:

Facebook Share on Facebook Twitter Tweet on Twitter Email Share by Email Pinterest Pin on Pinterest

French macarons are notoriously difficult to make, yet once mastered it's easy to look back and understand the reasons why they didn't work. With this in mind we've put together a list of five common problems when making French macarons and solutions to ensure success the next time round.

We've developed these tips for making French macarons using the Italian meringue method. We find the 'Italian method' more reliable - it is where you heat sugar into a syrup before whisking into the egg whites, forming a more stable meringue. However, the tips are still applicable to most other methods of making macarons.

1) Why do my macarons have nipples when piped?

The mixture hasn't spread properly when piped onto the baking tray. Tapping the baking tray a few times on a surface covered with a tea towel will help them to spread and lessen the nipples.

The deeper problem, however is that the macaron batter is likely to have been under-mixed. Use a spatula to mix the batter,firmly mixing the dry ingredients together withthe wet ones - the consistency is right when the mixture begins to look glossy around the edges. Test the mixture by prodding it with the end of the spatula, the batter should sink back into place after about 20 seconds.

This can also happen when the mixture is too dry. See (5) below for our tips on amount of water to add to the macaron mixture.

2)Why have my macarons cracked?

The piped macarons weren't dried out for long enough before being baked. The drying out process allows a skin to form on the top of the macarons which prevents the expanding air from escaping. If the skin isn't thick enough the expanding air will burst through it, causing the macarons to be cracked.

In our tried and tested macaron recipe we dried the macarons out overnight, for approximately 8-9 hours before baking. To speed things up we also found that macarons can be dried out for 20 minutes in a dehydrator on the lowest setting.

3) Why don't my macarons don't have feet?

This usually happens when the mixture has been overmixed. Many bakers recommend a certain number of folds to achieve the perfect results but this hinges on many variable factors so it's better to learn what the mixture should look like when it's ready - it will start to turn glossy around the edges and will fall back into place when prodded after 20 seconds.

Another cause for feetlessness may be underbeating the egg whites for the Italian meringue - they should just have reached the soft peak stage when you pour the hot syrup over them. Start beating the egg whites on full speed once the sugar syrup reaches 117°C, and by the time it reaches 121°C the egg whites should be sufficiently beaten.

If your macarons have very small 'flat' feet, it is because they have not been baked long enough. When you think the macarons are cooked, touch the edge of the feet. If they feel very delicate and sticky then bake for a little longer.

5 Common Problems When Making French Macarons (2)

These macarons were taken out of the oven too soon, as they have sunk back down into their 'foot' when cooling.

4) Why do my macarons have a bumpy surface or look blotchy?

Shop bought ground almonds contain fragments which need to be either sieved out of the mixture or ground more finely in a food processor. We recommend mixing together the ground almonds and icing sugar in a food processor and whizzing for a few seconds (10-15 seconds) - any more than this and the oils from the almond will start to be released and cause the macarons shells to look 'blotchy'. Remove from the food processor and pass through a fine sieve, discarding any larger fragments that won't pass through.

5 Common Problems When Making French Macarons (3)

You can see that the macarons in the bottom right have a slightly blotchy or 'oily' surface. The oil from the almonds has started to leach out, caused by over grinding the almonds or by over-mixing the macaron mixture.

5) Why aren't my macarons perfectly round?

This is often caused by irregular piping - try holding the piping bag perpendicular to the baking tray and draw evenly spaced circles on the underside of the parchment paper to guide you. Some recipes call for adding liquid food colour or powdered food colour dissolved in water - sometimes the mixture may spread unevenly even when piped correctly if it contains too much water. We recommend using no more than 1 tbsp of liquid per 200g of almond/icing sugar mixture.

5 Common Problems When Making French Macarons (4)

You can see the macarons have lifted in the oven and then landed to one side of their "feet". This can happen when the piping bag is not held perpendicular to the baking sheet.

Now you know how to avoid the common problems when making macarons, try thisstep-by-step guide to making raspberry macarons. Feeling inspired? Explore our large range of patisserie and baking products and find something exciting to bake with.

Share:

Facebook Share on Facebook Twitter Tweet on Twitter Email Share by Email Pinterest Pin on Pinterest

10 comments

  • Hi Imani,
    In order to get feet on your Macarons, you need to let them rest 30-60min after piping. They should be dry to the touch. The feet are created by air escaping, so the top need to be dry to ensure the air will only escape from the botton/sides = feet on your macarons. The cracks on the top is the air escaping.
    Hope this helps!
    Isobel

    Isobel at Sous Chef on

  • I have tasted these pretty cookies a few times and was I love but the price of one cookie in Georgia made me die so I chose to make them lol they tasted like the same cookie had the slight crunch but they did not have feet after being baked and they cracked at the top smh what did I do wrong I mixed dry ingredients untile I could make a figure 8 in the batter n stopped 🤷💁🤦

    Imani Hightower on

  • My Macarons cracked after drying for an hour

    Swati Dhameja on

  • I use the smallest melon baller I could find to scoop the batter onto the parchment paper and it works. You get perfectly sized Macarons without the fuss of piping.

    Alice on

  • Dehydrators are brilliant when you’re making catering-size batches of macarons – or shop loads, as you say! :-)

    nicola on

  • With that list of requirements it would be cheaper to BUY a shopload of macarons.

    Annie on

  • They are such a treat when you master them – and so much opportunity for dreaming up exciting flavours. Bonne chance!

    nicola on

  • Having travelled to France on many occasion during the past twenty years, it will be nice to perfect the art of macaron baking, wish me luck????

    John on

  • Assuming you are already using the titanium dioxide, then the beige tinge on macaron shells is indeed a thorny problem. If you have it with just these macarons but no others, I am not sure what to suggest. Perhaps give us a call in the office to talk through. However if it is with all macarons…

    I had it frequently with a previous oven, and people I asked about it never knew what I meant, and had no advice – it seemed oven specific. First try turning off fan. Then a combination of a slightly higher oven temperature and propping the door ajar throughout cooking to let steam escape / increase air flow (maybe using a tea towel) and playing around with cooking times helped. Eventually I achieved some consistency, but sadly it’s something you probably have to experiment with. Yet, with different ovens, I haven’t had the same issue.

    Does anyone else have any tips?

    nicola on

  • Hi, I’m making your salted caramel macaron recipe and having problems getting the shells to stay white. I’ve dropped the temp to 140c and put in the correct amount of colour but still they are tingled golden. can you please give me some advice?

    Kirsten on

5 Common Problems When Making French Macarons (2024)
Top Articles
7-Day High-Protein Anti-Inflammatory Meal Plan
Chili b ASMR - ASMR Role Play - Bio, Channel Info & Stats via asmrliving
Wordscapes Level 5130
Harry Potter Magic Awakened best cards tier list – July 2023
We Will Collide Someday Novel
Monkey Werx Sitrep 2022
Sigma Aldrich Calculator
Myvetstoreonline.pharmacy
Jacob Chapel Live Stream
Colossians 2 Amplified
Pga Us Open Leaderboard Espn
Nextdoor Myvidster
8 Internet Celebrities who fell prey to Leaked Video Scandals
Restaurant Depot Flyer December 2022
Spirited Showtimes Near Gqt Kalamazoo 10
Zipformsonline Plus Login
Gsmst Graduation 2023
Zom100 Mangadex
Gina's Pizza Port Charlotte Fl
MySDMC SSO: Manatee County’s Digital Educational Access
Sejinming Telegram
Craigslist Vt Heavy Equipment - Craigslist Near You
Frankie Beverly, the Maze singer who inspired generations of fans with lasting anthems, dies at 77
پنل کاربری سایت همسریابی هلو
Matrix Skilled Nursing Login
Think Up Elar Level 5 Answer Key Pdf
Jeep Graphics Ideas
Ketchum Who's Gotta Catch Em All Crossword Clue
Coverwood Terriers For Sale
Flixmate Chrome Extension
Kurlyrose
The Legend of Maula Jatt | Rotten Tomatoes
Odawa Hypixel
15 Best Things to Do in Tulare, CA - Travel Lens
100K NOTES - [DEEPWOKEN - DEEP WOKEN - ROBLOX] | ID 217435304 | PlayerAuctions
Paola Iezzi, chi è il compagno. L’uomo in comune con la sorella Chiara e le nozze 'congelate'
Arti kata petang-petang - Kamus Besar Bahasa Indonesia (KBBI) Online
Los Alamos Beach in Torremolinos: A Perfect Mediterranean Escape - Mama Málaga
Ups Store.near Me
Advanced Auto Body Hilton Head
America's Best Wings Raleigh Nc Rock Quarry
Ces 2023 Badge Pickup
Wgu Admissions Login
Wush Ear Cleaner Commercial Actor
Norville Breast Center At Alamance Regional
Shaws Myaci
Used Vehicles for Sale near Grandville, MI 49418 | U-Haul
Best Of Clinton Inc Used Cars
Braveheart Parents Guide
Hollyday Med Spa Prairie Village
Six Broadway Wiki
LP Vinyl Samling pop rock thrash metal trance
Latest Posts
Article information

Author: Dean Jakubowski Ret

Last Updated:

Views: 6011

Rating: 5 / 5 (50 voted)

Reviews: 81% of readers found this page helpful

Author information

Name: Dean Jakubowski Ret

Birthday: 1996-05-10

Address: Apt. 425 4346 Santiago Islands, Shariside, AK 38830-1874

Phone: +96313309894162

Job: Legacy Sales Designer

Hobby: Baseball, Wood carving, Candle making, Jigsaw puzzles, Lacemaking, Parkour, Drawing

Introduction: My name is Dean Jakubowski Ret, I am a enthusiastic, friendly, homely, handsome, zealous, brainy, elegant person who loves writing and wants to share my knowledge and understanding with you.