No-Knead Bread Recipe (2024)

No-Knead bread is justifiably popular due to its ease and good results. In side-by-side tests, we discovered that 90 seconds of extra work is all it takes to transform no-knead bread from good to great. Three simple folds, each taking about 30 seconds, will do the trick. We’ve also tweaked the ingredients to make a big improvement in the flavor of this simple bread.

Yield

One loaf

Timing

Start this bread at least 17 hours before serving time. While the exact timing of the folds isn’t important, it is good to space them out if possible. The long fermentation usually happens overnight, so it’s easy to do two folds before bed and then the third in the morning.

Ingredients

Ingredient	U.S. Volume	Grams
All-purpose or bread flour, unbleached	2¾ C*	400
Whole rye flour	¼ C*	30
Instant yeast	⅛ tsp	0.4
Salt, fine	1½ tsp	8.6
Water, about 70°F (21°C)	1⅓ C	317

* Measured by dipping the cup into a container of flour, then leveling off. If desired, all-purpose or bread flour can be substituted for the whole grain flour.

Equipment

Mixing bowl

Get Ready

Set the Proofer to 70°F (21°C) and put the water tray in the middle of the warming plate. Pour ¼ C (60 ml) water into the tray and place the rack on top of the tray.

Instructions

Mix the dough. In a large bowl, mix flour, yeast, and salt until well distributed, then add water and mix until dough is evenly hydrated. The dough will be very soft and sticky.

Ferment the dough. Cover the bowl and place in the Proofer to ferment at 70°F (21°C) for at least 12 and up to 16 hours. During this long fermentation, put the dough through three folding sessions, well spaced out. To fold the dough, use a wet hand or spatula to scrape a section of dough from the side of the bowl, then lift and stretch it a bit before folding it into the center of the bowl. Do this eight times for each folding session, traveling around the circumference of the bowl.

Shape the bread. After the long fermentation in the bowl and three folds are complete, our recipe follows the classic no-knead method for folding and shaping the dough. To shape the dough, scrape it out onto a floured work surface and give it a fourth eight-way fold, then cover and allow to rest for 15 minutes. While the dough is resting, prepare a sheet pan or plate with an oblong of parchment about 16″ / 41 cm long (the long ends will be used to lift and move the risen loaf).

Shape the dough into a round (one easy way to do this is with one last eight-way fold), brushing flour off as needed. If desired, stretch the outermost “skin” by brushing excess flour from the work surface, flipping the loaf seam side down and sliding the base towards you. Rotate the loaf and repeat to stretch the skin evenly (do not tear).

Proof the bread.Place the loaf seam side up on the parchment-lined pan or plate, cover with a generously floured kitchen towel and place the loaf in the Proofer, set to 72°F (22°C). Proof the bread until an indent in the side of the loaf springs back slowly, about 2½ hours.

Preheat the oven. About 20 minutes before you are ready to bake, place the bread steel in the lower ⅓ of your oven and preheat to 450°F (232°C). The steel heats quickly, and when the oven is ready, the bread steel will be too. There is no need to preheat the Bread Shell.

Bake the bread. When the loaf is finished proofing, use the oblong ends of the parchment to carefully lift the loaf and transfer it to a bread peel or a flat surface like an inverted sheet pan.

Slide your loaf (still seam side up)onto the hot steel and immediately cover it with the bread shell. Bake for 20 minutes with the shell on. Remove the shell, turn the oven down to 450°F (232°C), and continue baking for another 15 to 18 minutesuntilwell browned and the bread sounds hollow when knocked gently from the bottom.

Cool on a rack before slicing.

Overall Bread Formula:

Ingredient	Grams	Baker's %
Unbleached AP or Bread Flour	400	93
Whole Rye Flour	30	7
Instant Yeast	0.4	0.1
Salt	8.6	2
Water	317	74