Hot Fudge (2024)

FAQs

How do you know when fudge is hot enough? ›

The fudge is ready when a candy thermometer reads between 112°C to 114°C (234°F to 237°F) or the mixture forms a soft ball in cold water.

Cook the mixture over medium-low heat, without stirring, until the thermometer registers 234 degrees, about 20 to 25 minutes. The mixture should boil at a moderate, steady rate over the entire surface. While the fudge is cooking, prepare the baking pan.

How to fix soft fudge - Quora. Put it in a microwave safe bowl that is large enough that it won't boil over. Reheat it to the boiling point and cook for about 3 more minutes. Then you can beat some powdered sugar into it if this doesn't make it set.

This often happens when the condensed milk and chocolate chip mixture isn't hot enough to start. Everything must be completely melted before it is transferred to the pan to cool. Heat in 30-second bursts in the microwave, stirring well between each to ensure everything is melting evenly.

Avoid Stirring Once the Mixture Comes to a Simmer

Another key part of a successful fudge texture is when you stir the mixture. Stirring the sugar and milk during the initial stages of cooking allows the sugar to dissolve. However, once the mixture comes to a boil, it's time to put the spoon down.

Too cooked

The result is hard and brittle fudge. To save the fudge, put it in a saucepan with 45 to 60 ml (3 or 4 tbsp.) of 35% cream and bring to a boil, stirring until the sugar is completely melted. Then let it boil without stirring until the thermometer reaches 114 to 115 °C (237 to 239 °F).

Using a clean spoon, carefully take a little of the syrup and drop it into the bowl of cold water. Leave to cool for a moment then pick up the ball of syrup. If it's pliable, sticky and can be moulded in your fingers easily, it has reached the soft ball stage and the syrup can be used to make fudge and marzipan.

If it doesn't set, or if it sets very hard, you can add more milk and boil it again. However, even if it doesn't set, it'll usually be a nice frosting-like consistency, so I sometimes just make a cake to put under it.

Options for what you can do with your unset fudge:

OPTION 1) Depending on how runny it is, you can either use it as a frosting for cakes, or a sauce for ice-cream. OPTION 2) Freeze it overnight. Cut it into squares. Cover each square thickly in melted chocolate, ensuring no part of the fudge is exposed.

Don't Substitute One for the Other

Thus, using condensed milk in a recipe that requires evaporated milk will yield an overly sweet dish.

Why do you add baking soda to condensed milk? ›

Baking Soda will make the Milk thick and give creamy texture. Condensed Milk is ready. It is thick and creamy. Cool down to room temperature.

OMG My fudge is grainy, what do I do? -

Pop the grainy fudge back into the pan along with some water and a little cream and melt the fudge back down to a liquid and re-boil it to temperature. Heat slowly to begin with and make sure the mixture goes completely smooth before bringing it to the boil.

It could be that your fudge is overcooked and this causes the sugar to harden. A sugar thermometer will help you to check it reaches the correct temperature which is the soft ball stage at 112 to 116 °C (234 to 241 °F). If it exceeds this, it is heading for a much chewier consistency.

Once the fudge has thickened and the nuts are added, pour the fudge into the prepared pan. Allow it to set at room temperature until firm, about three hours or overnight.

For me, boiling for 3 minutes is ideal. And I always let the fudge cool just a bit before serving. You really don't want to waste a good fudge on a burnt tongue.